A typical standing seam panel can be approximately 12 16 and 19 inches wide.
Standing seam metal roof flashing details.
Double lock seam symmetrical seam one piece snap lock interlock and two piece snap lock interlock.
The trim and roofing sheet should be fastened every 12 to 24 inches along the gable edge.
Panel endwall flashing counter flashing butyl tape or tube sealant.
The continuous locking strip is soldered to the valley flashing.
Standing seam panels offer sleek lines that create a modern look.
Locate round penetrations centrally in the panel seal with butyl tape beneath base.
Thermal expansion contraction of steel panels metal flashing and trim should be installed with sealed end laps that allow for expansion and contraction.
At the gable edge use a gable or sidewall flashing.
The panels can be roll formed at the job site or at your local roofing materials supply warehouse.
The copper roofing laps the valley flashing a minimum of 6 and is folded and locked into a continuous copper locking strip.
Clipless one piece positive locking standing seam panel that provides a timeless roof appearance.
Panels should be installed with a fixed end and a free end.
This will keep weather out prevent lifting in high winds and provide a neat finished appearance.
Then fillet with one part polyurethane.
Other flashings include gable trim which runs up the sloped ends of the roof and drip edge or eave trim.
The connecting point where the two separate metal panels meet forms a vertically pointed rib or a seam that is one inch to inch and a half high.
This detail shows a method of detailing a valley condition on a standing seam roof.
The most common flashing for standing seam roofing is the ridge cap which is used at the peak of a roof where two opposing roof slopes join and attaches to the roof with z flashing.
Colonial seam continuous standing seam metal roof panel with an integral seam.
This manner allows for expansion and contraction to be controlled uniformly at one end of the roof.
Endwall details for standing seam endwall option 1 using counter flashing panel goes down first then the z channel and then the endwall flashing then the counter flashing and finally the tube sealant.
To provide a drip edge allow an overhang of 1 to 2 inches at the eave.
There are four basic standing seam metal roof panel styles.